CNANGING THE COMBINATION To change the combination, you will need the existing combination and a Change Key . Procedures as Following : 1. With lock bolt fully retracted (lock open) , before changing combinations , verify that the dial stops between 90 and 100 on the OPENING INDEX. 2. Dial the existing combination(10-20-30) , as previously described , on the CHANGING index , but stop the third dial combination (30) on exactly CHANGING INDEX not opening index . 3. In the back of the door , insert the Change key into the key hole . If the Change Key does not go it easily , the wheels are not aligned for changing . Redial the existing combination on the CHANGING INDEX. 4. Turn the Changing Key to the LEFT (Rotate90°CCW) until it stops . Leave the key in the lock . 5. Select a new combination , such as 40-50-60 . Never select number from 0 to 20 as the last number of the combination, this is a forbidden zone . 6. Still using the CHANGING INDEX , turn the dial to the LEFT and pass 40 three times and stop exactly on 40 the fourth time , aligning the number with the CHANGE Index 7. Turn the dial to the RIGHT and pass 50 two time and stop exactly on 50 the third time , aligning the number with the CHANGING Index. 8. Turn the dial to the Left pass 60 once and stop exactly on 60 the second time , aligning the number with the CHANGING Index. Leave the dial on 60 . 9. Turn the Changing Key to the RIGHT until it stops and remove the key. 10. Completely dial the new combination (40-50-60) using the OPENING INDEX several times
|